Process Engineer

Process Engineer /Process Design Engineer

Process design and engineering experience of 8 to 12+ years in Oil & Gas projects upstream projects, pipeline projects covering design, conceptual engineering, FEED, Detailed engineering.

Required Experience

The candidate should have experience in preparing the following deliverables for Basic Engineering, FEED, or EPC projects with a reputed international EPC consultant.

• Design Basis
• Licensor Technology Evaluation
• PFD and P&ID Preparation and or review for Urea Plant
• HMB
• Process data sheets, Equipment list, Line list, Load list, Tie-In list, Fluid list,
• PSV Relief load estimation, PSV sizig
• Flare sizing, KOD sizing
• Pump sizing
• Compressor Calculations, Anti surge design, settle out calculations etc
• Steam generation and sizing calculations
• Design of Separators, columns, Heat Exchangers, tanks
• Hydraulic calculations, PSV sizing, Control valve sizing calculations
• Interfacing with Piping, Mechanical Instrument engineers, Commissioning Engineers as required during the EPC stages
• 3D Model Review
• vendor offer reviews
• Experience across conceptual design, FEED, and detailed engineering phases.
• Operation experience is not preferred.

Software/Technical Skills & Tools

- Experience with process simulation and engineering software such as HYSYS, PROMAX, Flare network analysis tools, and HTRI.

- Strong understanding of process design, sizing, and optimization techniques.

- Ability to critically review calculations and propose practical engineering solutions.

- Strong technical documentation and report-writing skills.

- Fluent in spoken and written English.

Education

• B tech Chemical Engineering / MTech Chemical Engineering
• 75% Marks in engineering are mandatory

Job Profile

Key Responsibilities

- Perform process design review and verification across conceptual, FEED, and detailed engineering stages.

- Prepare and review process design basis, philosophies, and engineering calculations.

- Review and verify Process Flow Diagrams (PFDs), Piping & Instrumentation Diagrams (P&IDs), and Heat & Material Balances (HMB).

- Review process datasheets, equipment lists, line lists, tie-in lists, fluid and load lists.

- Perform and review PSV relief load estimation and PSV sizing calculations.

- Review flare system calculations, knockout drum sizing, and associated hydraulics.

- Review pump, compressor, and rotating equipment process calculations including anti-surge and settle-out analyses.

- Review design of separators, columns, heat exchangers, tanks, and other process equipment.

- Perform hydraulic calculations and control valve sizing reviews.

- Interface with piping, mechanical, electrical, and instrumentation disciplines during EPC execution.

- Participate in 3D model reviews and vendor technical document reviews.

- Prepare and review technical reports, calculation notes, and design review comments.

- Ensure compliance with applicable international codes, standards, and project procedures.

- Site Visit : The candidate may be required to occasionally visit project sites to conduct audits or verification activities.